Many people do not satisfied with single color for decoration requirement. Changeable color make the environment more lively. 5050 RYGB color changing LED strip light will be a good choice, controlled by IR controller.
The first, let us know more about the LED strip light. All the LED strip light come with the easy-plug 4-pin end on could easy connect to controller. UL-listed power adapter assure the safety usage.
We could set up the IR controller changing model by ourselves. On the remote we could see a DIY button ,that allows you to create your favorite color and save it. First step, pressing the IC Set button, which will make the controller into the DIY color mode; we could adjust the color with the up & down arrow keys to increase or decrease the red, green, and blue to create your unique color.
When we confirm the changing model, pressing the IC set key again to save it to your controller. That specific color will show up when the IC key is pressed gain after the power cycle.
The controller could create and memory multiple chasing effect. As following :
All color or less colors chasing from left to right, right to left
All color or less colors flow from two terminals to center and from center to two terminals
All color or less colors trail into left or right or two directions in turn
All color or less colors spread to left or right
All colors in jump, flash, queued, auto-cycle mode
The color changing LED strip lights can be used in many aspects. Interior and exterior color chasing LED strip lights allow custom colored custom colored lighting to windows, doors, cars or walls. Most LED strips can be customized lengths and sizes. 12V/24V color chasing LED strip lights have adhesive backs allowing you to place them onto clean surfaces. Here some tips for you to use the color chasing LED strip lights.
First, washing the surface which you want to place the LED strips. If attaching them to a car running board or bumper, you can use soapy water and sponges to clean the surface of grime and grit. You should also clean any glass surfaces before adding the color chasing LED strip lights.
Then, measure out the distance you want LED lights added. You can cut down the color chasing LED strip lights using scissors or a knife. If your color chasing LED strip lights use adhesive backing, you may peel the tape from the back and place the color chasing LED strip lights onto the surface, sticky side down.
At last, you just plug the red and black wires into the 12-volt battery tab, typically included with the LED strips and plug the tab onto the top of the battery to turn on the lights.
Now the color changing LED strip light is working!
